SIST EN ISO 10352:2020

Oznaka standarda: SIST EN ISO 10352:2020
Koda projekta: 00249968
Organizacija: SIST
Naslov (angleški): Fibre-reinforced plastics - Moulding compounds and prepregs - Determination of mass per unit area and fibre mass per unit area (ISO 10352:2020)
Naslov (slovenski): Z vlakni ojačeni polimerni materiali - Zmesi za oblikovanje in preimpregniranje - Ugotavljanje mase na enoto površine in mase vlaken na enoto površine (ISO 10352:2020)
Če kupite standardizacijski dokument v .pdf formatu prek spletne prodaje, vam nudimo 20% popust pri spodnji ceni brez DDV. Cenik SIST
Dokumenti
Ime Jezik Status Cena Dodaj v košarico
SIST EN ISO 10352:2020 angleški jezik Active SIST-F: 65.34 EUR
PDF
Papir
Tehnični odbor: IPMA - Polimerni materiali in izdelki
ICS: 17.060 83.120
Status: Objavljen
Objavljen: 01-Dec-2020
Refer. št. objave: Sporocila 2020-12
Referenčna oznaka: EN ISO 10352:2020
Področje projekta (angleško): This document specifies a method for the determination of the mass per unit area. It also specifies five methods (Method A to Method E) for the determination of the fibre mass per unit area of moulding compounds and prepregs. The five methods are as follows: — Method A: Extraction by Soxhlet; — Method B: Extraction by immersion in solvent in a beaker; — Method C: Decomposition by loss ignition; — Method D: Extraction by wet combustion; — Method E: Method by calculation. This document is applicable to the following types of materials: — moulding compound and preimpregnated unidirectional sheet, tape, fabric and mats; — prepregs in which any type of reinforcement (aramid, carbon, glass, etc.) and any type of matrix (thermosetting or thermoplastic) has been used. Typically, reinforcement fibres are coated with sizing or finishes. These normally dissolve with the resin and are, therefore, included in the resin content. This document is not applicable to the following types of prepregs: — those containing reinforcements which are soluble (or partly soluble) in the solvents used to dissolve the resin.
Povezava na standarde
Povezava Ime Datum
Revidiran SIST EN ISO 10352:2011 - Z vlakni ojačeni polimerni materiali - Zmesi za oblikovanje in preimpregniranje - Določevanje mase na enoto površine (ISO 10352:2010) 13-Jan-2016
Nadomešča SIST EN ISO 10352:2011 - Z vlakni ojačeni polimerni materiali - Zmesi za oblikovanje in preimpregniranje - Določevanje mase na enoto površine (ISO 10352:2010) 30-Sep-2020


• Slovenski standardi SIST s cenovnim razredom AC so popravki standardov in so v večini primerov brezplačni.

• Slovenski standardi SIST s cenovnim razredom AP so privzeti tuji standardi, katerih sestavni del je izvirni standard, ki ga moramo pridobiti pri izdajatelju v tujini. Naročilo pošljite na: prodaja@sist.si.

Najbolje prodajani standardi