SIST EN 13353:2009/kFprA1:2010
(Amendment)Solid wood panels (SWP) Requirements
Solid wood panels (SWP) Requirements
This European Standard specifies requirements for solid wood panels as defined in EN 12775 for use in dry, humid and exterior conditions as defined in service classes 1, 2 and 3 of EN 1995-1-1
Massivholzplatten (SWP) - Anforderungen
Bois panneautés - Exigences
Masivne lesne plošče (SWP) - Zahteve
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 13353:2009/kFprA1:2010
01-november-2010
0DVLYQHOHVQHSORãþH 6:3 =DKWHYH
Solid wood panels (SWP) Requirements
Massivholzplatten (SWP) - Anforderungen
Bois panneautés - Exigences
Ta slovenski standard je istoveten z: EN 13353:2008/FprA1
ICS:
79.060.99 'UXJHOHVQHSORãþH Other wood-based panels
SIST EN 13353:2009/kFprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 13353:2009/kFprA1:2010
---------------------- Page: 2 ----------------------
SIST EN 13353:2009/kFprA1:2010
EUROPEAN STANDARD
FINAL DRAFT
EN 13353:2008
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
September 2010
ICS 79.060.99
English Version
Solid wood panels (SWP) Requirements
Bois panneautés - Exigences Massivholzplatten (SWP) - Anforderungen
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 112.
This draft amendment A1, if approved, will modify the European Standard EN 13353:2008. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without not
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.