iTeh StandardsiTeh Standards
EURUSD
Your shopping cart is empty.
SIST

SIST EN 50083-3:1995

(Main)

Cabled distribution systems for television and sound signals -- Part 3: Active coaxial wideband distribution equipment

Cabled distribution systems for television and sound signals -- Part 3: Active coaxial wideband distribution equipment

This standard - applies to all broadband amplifiers used in cabled distribution systems; - covers the frequency range 5 MHz to 1 750 MHz; - applies to one-way and two-way equipment; - lays down the basic methods of measurement of the operational characteristics of the active equipment in order to assess the performance of this equipment; - identifies the performance specifications that shall be published by the manufacturers; - states the minimum performance requirements of certain parameters. Amplifiers are divided into the following two quality levels: Grade 1 - Amplifiers typically intended to be cascaded. Grade 2 - Amplifiers for use typically within an apartment block, or within a single residence, to feed a few outlets. Practical experience has shown these types meet most of the technical requirements necessary for supplying a minimum signal quality to the subscribers. This classification shall not be considered as a requirement but as the information for users and manufacturers on the minimum quality criteria of the material required to install networks of different sizes. The system operator has to select appropriate material to meet the minimum signal quality at the subscriber's outlet, and to optimise cost/performance, taking into account the size of the network and local circumstances. All requirements and published data are understood as guaranteed values within the specified frequency range and in well matched conditions.

Kabelverteilsysteme für Ton- und Fernsehrundfunk-Signale -- Teil 3: Aktive Breitbandgeräte für koaxiale Verteilnetze

Systèmes de distribution par câble destinés aux signaux de radiodiffusion sonore et de télévision -- Partie 3: Matériels actifs utilisés dans les systèmes de distribution coaxiale à large bande

Kabelski distribucijski sistemi za televizijsko in zvokovno radiofuzijo - 3. del: Aktivna koaksialna širokopasovna distribucijska oprema

General Information

Status
Withdrawn
Publication Date
28-Feb-1995
Withdrawal Date
30-Jun-1999
ICS
33.060.40 - Cabled distribution systems
33.120.10 - Coaxial cables. Waveguides
Technical Committee
RZV - Radiocommunication
Current Stage
9900 - Withdrawal (Adopted Project)
Start Date
01-Jul-1999
Due Date
01-Jul-1999
Completion Date
01-Jul-1999
Directive
73/23/EEC - Electrical equipment designed for use within certain voltage limits
Ref Project
EN 50083-3:1994 - Cabled distribution systems for television and sound signals - Part 3: Active coaxial wideband distribution equipment

Relations

Replaced By
SIST EN 50083-3:1999 - Cable networks for television signals, sound signals and interactive services -- Part 3: Active wideband equipment for coaxial cable networks
Effective Date
29-Jan-2023
Replaced By
SIST EN 50083-3:1999 - Cable networks for television signals, sound signals and interactive services -- Part 3: Active wideband equipment for coaxial cable networks
Effective Date
06-May-2014

Buy Standard

EN 50083-3:1995EN 50083-3:1995
PreviousNext
Standard
EN 50083-3:1995
English language
42 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 50083-3:1995
01-marec-1995
Kabelski distribucijski sistemi za televizijsko in zvokovno radiofuzijo - 3. del:
Aktivna koaksialna širokopasovna distribucijska oprema
Cabled distribution systems for television and sound signals -- Part 3: Active coaxial
wideband distribution equipment
Kabelverteilsysteme für Ton- und Fernsehrundfunk-Signale -- Teil 3: Aktive
Breitbandgeräte für koaxiale Verteilnetze
Systèmes de distribution par câble destinés aux signaux de radiodiffusion sonore et de
télévision -- Partie 3: Matériels actifs utilisés dans les systèmes de distribution coaxiale à
large bande
Ta slovenski standard je istoveten z: EN 50083-3:1994
ICS:
33.060.40 Kabelski razdelilni sistemi Cabled distribution systems
33.120.10 Koaksialni kabli. Valovodi Coaxial cables. Waveguides
SIST EN 50083-3:1995 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 2 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 3 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 4 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 5 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 6 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 7 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 8 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 9 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 10 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 11 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 12 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 13 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 14 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 15 ----------------------

SIST EN 50083-3:1995

---------------------- Page: 16 ----------------------

SIST EN 50083-3:1995

--------
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.

This May Also Interest You

SIST
SIST EN 50607:2015(Main)
Satellite signal distribution over a single coaxial cable - Second generation
EN 50607:2015

This European Standard describes:
▪ the system physical structure;
▪ the system control signals, which implement a set of messages using DiSEqC physical layer but not the
DiSEqC message structure;
▪ the definition of identified configurations;
▪ the management of the potential collisions in the control signals traffic.
Figure 1 illustrates the physical system configuration considered in this standard.
Several satellite signal demodulators can receive signals from any of the input signal banks (Bank 1, Bank 2,
Bank M, with M ≤ 256) of the LNB or the switch. The signals selected by the demodulators (or receivers) are
transported via a single cable to these demodulators (Receiver 1, Receiver 2, Receiver N, with N ≤ 32).
To achieve these single cable distributions, the Single Cable Interface (SCIF, likely embedded in a LNB or a
Switch) features some specific functions and characteristics.
Figure

  • Standard
    28 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN 60728-4:2008(Main)
Cable networks for television signals, sound signals and interactive services -- Part 4: Passive wideband equipment for coaxial cable networks
EN 60728-4:2008

This part of IEC 60728 applies to system outlets, splitters and taps, passive single or multiple port equipment comprising filters, attenuators, equalizers, galvanic isolators, power injectors, cable splices, terminating resistors and transfer points, but excluding coaxial cables and receiver leads.

  • Standard
    38 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST-TP CEN/TR 12349:2023(Main)
Mechanical vibration - Guide to the health effects of vibration on the human body
CEN/TR 12349:2023

The aim of this CEN report is to provide information on the possible adverse health effects caused by exposure to vibration at work.  the report addresses manufacturers as well as employers and employees using vibrating machinery in order to improve their understanding of the possible health problems arising from occupational exposure to vibration.

  • Technical report
    17 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 80004-1:2023(Main)
Nanotechnologies - Vocabulary - Part 1: Core vocabulary (ISO 80004-1:2023)
EN ISO 80004-1:2023

This document defines core terms in the field of nanotechnology. This document is intended to facilitate communication between organizations and individuals in industry and those who interact with them.

  • Standard
    24 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    25 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 3262-4:2023(Main)
Extenders - Specifications and methods of test - Part 4: Whiting (ISO 3262-4:2022)
EN ISO 3262-4:2023

This document specifies requirements and corresponding methods of test for whiting.

  • Standard
    11 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    9 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 1247-1:2023(Main)
Aluminium pigments for paints - Part 1: General aluminium pigments (ISO 1247-1:2021)
EN ISO 1247-1:2023

This document specifies the requirements and corresponding test methods for aluminium pigments suitable for use in paints including:
a) general, decorative and protective paints, and
b) special finishing paints.

  • Standard
    33 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    30 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 18473-4:2023(Main)
Functional pigments and extenders for special applications - Part 4: Nanoscale titanium dioxide for photocatalytic application (ISO 18473-4:2022)
EN ISO 18473-4:2023

This document specifies requirements and corresponding test methods for nanoscale titanium dioxide (TiO2) in either powder or suspension form for photocatalytic application.
This document is applicable to modified nanoscale titanium dioxide for photocatalytic application. Such modification can be surface treatment, coating, doping and combination thereof.

  • Standard
    13 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    10 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 3262-22:2023(Main)
Extenders - Specifications and methods of test - Part 22: Flux-calcined kieselguhr (ISO 3262-22:2023)
EN ISO 3262-22:2023

This document specifies requirements and corresponding methods of test for flux-calcined kieselguhr.

  • Standard
    11 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    8 pages
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN IEC 63044-4:2021/AC:2023(Corrigendum)
Home and building electronic systems (HBES) and building automation and control systems (BACS) - Part 4: General functional safety requirements for products intended to be integrated in HBES and BACS
EN IEC 63044-4:2021/AC:2023-07
  • Corrigendum
    1 page
    English language
    sale 10% off
    e-Library read for
    1 day
SIST
SIST EN ISO 3262-3:2023(Main)
Extenders - Specifications and methods of test - Part 3: Blanc fixe (ISO 3262-3:2023)
EN ISO 3262-3:2023

This document specifies requirements and corresponding methods of test for blanc fixe.

  • Standard
    14 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    10 pages
    English language
    sale 10% off
    e-Library read for
    1 day