SIST EN 16474:2015

Oznaka standarda: SIST EN 16474:2015
Koda projekta: 00145070
Organizacija: SIST
Naslov (angleški): Plastics and rubber machines - Tyre curing presses - Safety requirements
Naslov (slovenski): Stroji za predelavo gume in plastike - Stiskalnice za vulkaniziranje - Varnostne zahteve
Če kupite standardizacijski dokument v .pdf formatu prek spletne prodaje, vam nudimo 10% popust pri spodnji ceni brez DDV. Cenik SIST
Dokumenti
Ime Jezik Status Cena Dodaj v košarico
SIST EN 16474:2015 angleški jezik Active SIST-L: 111.32 EUR
PDF
Papir
Tehnični odbor: VSN - Varnost strojev in naprav
ICS: 25.120.10 83.200
Status: Objavljen
Objavljen: 01-jul-2015
Refer. št. objave: Sporocila 2015-07
Referenčna oznaka: EN 16474:2015
Področje projekta (angleško): This European Standard applies to the tyre curing presses as defined in 3.36 having the following configuration. - Crossing flow tyre curing presses, with two cavities with: - common curing cycle and common safeguarding; or - independent curing cycles and common safeguarding; or - independent curing cycles and independent safeguarding. - Tyre curing presses with one cavity. - Tyre curing presses with automatic rear feeding and discharge. The requirements and/or safety measures specified in this European Standard apply to tyre curing presses for passenger vehicle tyres and truck tyres. Only automatic tyre loading into the mould and automatic tyre unloading from the mould are covered by this European Standard. Feeding system and discharge system are not covered by this European Standard. Hazard associated with falling of parts of the container or mould are not covered by this European Standard. Safety requirements relating to the design of ancillary equipment which is not an integral part of the tyre curing press, e.g. conveying equipment are not covered in this European Standard. Safety requirements relating the design of exhaust systems are not covered in this European Standard. This European Standard covers the significant hazards listed in Clause 4. NOTE This European Standard is not intended to support the PED [1]. For pressure hazards, see informative Annex A. This document is not applicable to tyre curing presses which are manufactured before the date of its publication as EN.

Najbolje prodajani standardi