SIST EN 12312-16:2005+A1:2009

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Luftfahrt-Bodengeräte - Besondere Anforderungen - Teil 16: LuftstartgeräteMatériel au sol pour aéronefs - Exigences particulières - Partie 16: Matériels de démarrage à airAircraft ground support equipment - Specific requirements - Part 16: Air start equipment49.100Oprema za servis in vzdrževanje na tlehGround service and maintenance equipmentICS:Ta slovenski standard je istoveten z:EN 12312-16:2005+A1:2009SIST EN 12312-16:2005+A1:2009en,de01-julij-2009SIST EN 12312-16:2005+A1:2009SLOVENSKI
STANDARD



SIST EN 12312-16:2005+A1:2009



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12312-16:2005+A1
April 2009 ICS 49.100 Supersedes EN 12312-16:2005English Version
Aircraft ground support equipment - Specific requirements - Part 16: Air start equipment
Matériel au sol pour aéronefs - Exigences particulières - Partie 16: Matériels de démarrage à air
Luftfahrt-Bodengeräte - Besondere Anforderungen - Teil 16: Luftstartgeräte This European Standard was approved by CEN on 13 June 2005 and includes Amendment 1 approved by CEN on 1 March 2009.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2009 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 12312-16:2005+A1:2009: ESIST EN 12312-16:2005+A1:2009



EN 12312-16:2005+A1:2009 (E) 2 Contents Page Foreword . 3Introduction . 41 Scope . 52 Normative references . 53 Terms and definitions . 64 List of hazards . 65 Safety requirements and/or measures . 75.1 General requirements . 75.2 Stored air systems . 75.3 Diesel powered air start units . 75.3.1 Power source . 75.3.2 Air compressor . 75.3.3 Air delivery system . 85.4 Turbine powered air start units . 85.4.1 Power source . 85.4.2 Air compressor . 85.4.3 Air delivery system . 85.5 Air delivery hoses . 85.6 Controls, monitoring devices and displays . 95.7 Options . 96 Information for use . 96.1 Marking . 96.2 Additional marking . 96.3 Instructions . 97 Verification of requirements . 10Annex A (informative)
Examples of air start units . 11Annex B (normative)
List of hazard in addition to those of EN 1915-1 . 13Annex ZA (informative)
Relationship between this European Standard and the Essential Requirements of EU Directive 98/37/EC . 14Annex ZB (informative)
!!!!Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC"""" . 15Bibliography . 16 SIST EN 12312-16:2005+A1:2009



EN 12312-16:2005+A1:2009 (E) 3 Foreword This document (EN 12312-16:2005+A1:2009) has been prepared by Technical Committee CEN/TC 274 "Aircraft ground support equipment", the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by October 2009, and conflicting national standards shall be withdrawn at the latest by December 2009. This document includes Amendment 1, approved by CEN on 2009-03-01. This document supersedes EN 12312-16:2005. The start and finish of text introduced or altered by amendment is indicated in the text by tags ! ". This European Standard has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association and supports essential requirements of EU Directive(s). !For relationship with EU Directives, see informative Annexes ZA and ZB, which are integral parts of this document." The Parts of EN 12312 — Aircraft ground support equipment — Specific requirements — are: Part 1: Passenger stairs Part 2: Catering vehicles Part 3: Conveyor belt vehicles Part 4: Passenger boarding bridges Part 5: Aircraft fuelling equipment Part 6: Deicers and deicing/antiicing equipment Part 7: Air-craft movement equipment Part 8: Maintenance stairs and platforms Part 9: Container/Pallet loaders Part 10: Container/Pallet transfer transporters Part 11: Container/Pallet dollies and loose load trailers Part 12: Potable water service equipment Part 13: Lavatory service equipment Part 14: Disabled/Incapacitated passenger boarding equipment Part 15: Baggage and equipment tractors Part 16: Air start equipment Part 17: Air conditioning equipment Part 18: Nitrogen or Oxygen units Part 19: Aircraft jacks, axle jacks and hydraulic tail stanchions Part 20: Ground power equipment According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. SIST EN 12312-16:2005+A1:2009



EN 12312-16:2005+A1:2009 (E) 4 Introduction This European Standard specifies health and safety requirements, as well as some functional and performance requirements for air start equipment intended for servicing all aircraft types commonly in service in civil air transport. The minimum essential criteria are considered to be of primary importance in providing safe, serviceable, economical and practical air start equipment. Deviations from the recommended criteria should occur only after careful consideration, extensive testing, risk assessment and thorough service evaluation have shown alternative methods or conditions to be satisfactory. This European Standard is a Type C standard as stated in EN ISO 12100. The machinery concerned and the extent to which hazards, hazardous situations and events are covered are indicated in the scope of this European Standard. When provisions of this type C standard differ from those which are stated in type A or B standards, the provisions of this type C standard take precedence over the provisions of the other standards, for machines that have been designed and built according to the provisions of this type C standard. SIST EN 12312-16:2005+A1:2009



EN 12312-16:2005+A1:2009 (E) 5
1 Scope This European Standard specifies the technical requirements to minimise the hazards listed in Clause 4 which can arise during the commissioning, operation and maintenance of air start equipment when carried out in accordance with the specifications given by the manufacturer or his authorised representative. It also takes into account some performance requirements recognised as essential by authorities, aircraft and ground support equipment (GSE) manufacturers as well as airlines and handling agencies. This European Standard applies to the following types of air start equipment used for civil aircraft:  stored air systems without compressors;  mobile diesel powered air start units;  mobile turbine powered air start units;  air delivery systems of ramp or passenger boarding bridges, as defined in Clause 3 (Examples see Annex A). This European Standard does not establish requirements for the pressure vessels included in the air start equipment. This European Standard does not establish requirements for noise and vibration. Noise and vibration are dealt with respectively in EN 1915-4 and EN 1915-3. This European Standard does not deal with hazards in respect to a standard automotive chassis and from other vehicles on the apron. This Part of EN 12312 is not applicable to air start equipment which is manufactured before the date of publication of this European Standard by CEN. !This part of EN 12312 is intended to be used in conjunction with EN 1915-1, EN 1915-2, EN 1915-3 (for vehicles) and EN 1915-4." 2 Normative references The following referenced documents are indispensable for the application of this European Standard. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. !deleted text" EN 1012-1, Compressors and vacuum pumps — Safety requirements — Part 1: Compressors EN 1050:1996, Safety of machinery — Principles for risk assessment EN 1915-1:2001, Aircraft ground support equipment — General requirements — Part 1: Basic safety requirements EN 1915-2, Aircraft ground support equipment — General requirements — Part 2: Stability and strength requirements, calculations and test methods !EN 1915-3, Aircraft ground support equipment — General requirements — Part 3: Vibration measurement methods and reduction" !EN 1915-4, Aircraft ground support equipment — General requirements — Part 4: Noise measurement methods and reduction" EN ISO 12100-1:2003, Safety of machinery — Basic concepts, general principles for design — Part 1: Basic termi-nology, methodology (ISO 12100-1:2003) SIST EN 12312-16:2005+A1:2009



EN 12312-16:2005+A1:2009 (E) 6 EN ISO 12100-2:2003, Safety of machinery — Basic concepts, general principles for design — Part 2: Technical principles (ISO 12100-2:2003) !EN ISO 13850:2008, Safety of machinery — Emergency stop — Principles for design (ISO 13850:2006)" ISO 2026, Aircraft — Connections for starting engines by air
3 Terms and definitions For the purposes of this European Standard, the terms and definitions given EN 1915-1:2001 and EN ISO 12100
...