SIST EN ISO 105-G01:2016

SLOVENSKI STANDARD
SIST EN ISO 105-G01:2016
01-september-2016
1DGRPHãþD
SIST EN ISO 105-G01:1999
SIST EN ISO 105-G01:1999/AC:1999
Tekstilije - Preskušanje barvne obstojnosti - Del G01: Barvna obstojnost proti
dušikovim oksidom (ISO 105-G01:2016)
Textiles - Tests for colour fastness - Part G01: Colour fastness to nitrogen oxides (ISO
105-G01:2016)
Textilien - Farbechtheitsprüfungen - Teil G01: Farbechtheit gegen Stickoxide (ISO 105-
G01:2016)
Textiles - Essais de solidité des teintures - Partie G01: Solidité des teintures aux oxydes
d'azote (ISO 105-G01:2016)
Ta slovenski standard je istoveten z: EN ISO 105-G01:2016
ICS:
59.080.01 Tekstilije na splošno Textiles in general
SIST EN ISO 105-G01:2016 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 105-G01:2016

---------------------- Page: 2 ----------------------

SIST EN ISO 105-G01:2016


EN ISO 105-G01
EUROPEAN STANDARD

NORME EUROPÉENNE

June 2016
EUROPÄISCHE NORM
ICS 59.080.01 Supersedes EN ISO 105-G01:1995
English Version

Textiles - Tests for colour fastness - Part G01: Colour
fastness to nitrogen oxides (ISO 105-G01:2016)
Textiles - Essais de solidité des teintures - Partie G01: Textilien - Farbechtheitsprüfungen - Teil G01:
Solidité des teintures aux oxydes d'azote (ISO 105- Farbechtheit gegen Stickoxide (ISO 105-G01:2016)
G01:2016)
This European Standard was approved by CEN on 12 May 2016.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2016 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 105-G01:2016 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 105-G01:2016
EN ISO 105-G01:2016 (E)
Contents Page
European foreword . 3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 105-G01:2016
EN ISO 105-G01:2016 (E)
European foreword
This document (EN ISO 105-G01:2016) has been prepared by Technical Committee ISO/TC 38
"Textiles" in collaboration with Technical Committee CEN/TC 248 “Textiles and textile products” the
secretariat of which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by December 2016, and conflicting national standards
shall be withdrawn at the latest by December 2016.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent
rights.
This document supersedes EN ISO 105-G01:1995.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands,
Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the
United Kingdom.
Endorsement notice
The text of ISO 105-G01:2016 has been approved by CEN as EN ISO 105-G01:2016 without any
modification.
3

---------------------- Page: 5 ----------------------

SIST EN ISO 105-G01:2016

---------------------- Page: 6 ----------------------

SIST EN ISO 105-G01:2016
INTERNATIONAL ISO
STANDARD 105-G01
Third edition
2016-06-01
Textiles — Tests for colour fastness —
Part G01:
Colour fastness to nitrogen oxides
Textiles — Essais de solidité des teintures —
Partie G01: Solidité des teintures aux oxydes d’azote
Reference number
ISO 105-G01:2016(E)
©
ISO 2016

---------------------- Page: 7 ----------------------

SIST EN ISO 105-G01:2016
ISO 105-G01:2016(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2016, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2016 – All rights reserved

---------------------- Page: 8 ----------------------

SIST EN ISO 105-G01:2016
ISO 105-G01:2016(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Principle . 1
4 Apparatus and materials. 1
5 Conditioning and testing atmosphere . 3
6 Test specimens. 3
7 Procedure. 3
7.1 Preliminary operations . 3
7.2 One-cycle test . 3
7.3 Three-cycle test . 4
7.4 Conditioning . 4
8 Test report . 4
Annex A (normative) Test apparatus . 6
Annex B (normative) Nitric oxide generation apparatus . 8
Bibliography .10
© ISO 2016 – All rights reserved iii

---------------------- Page: 9 ----------------------

SIST EN ISO 105-G01:2016
ISO 105-G01:2016(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity
assessment, as well as information about ISO’s adherence to the WTO principles in the Technical
Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information.
The committee responsible for this document is ISO/TC 38, Textiles, Subcommittee SC 1, Tests for
coloured textiles and colorants.
This third edition cancels and replaces the second edition (ISO 105-G01:1993), which has been
technically revised. It also incorporates the Technical Corrigendum ISO 105-G01:1993/Cor 1:1995. The
main technical changes are the following:
a) the test-control fabric dyed with Disperse Blue 3 was deleted;
b) the test-control fabric dyed with Disperse Violet 1 and the test-control fabric dyed with Disperse
Blue 56 were added.
ISO 105 consists of many parts designated by a part letter and a two-digit serial number (e.g. A01), under
the general title Textiles — Tests for colour fastness. A complete list of these is given in ISO 105-A01.
iv © ISO 2016 – All rights reserved

---------------------- Page: 10 ----------------------

SIST EN ISO 105-G01:2016
INTERNATIONAL STANDARD ISO 105-G01:2016(E)
Textiles — Tests for colour fastness —
Part G01:
Colour fastness to nitrogen oxides
1 Scope
This part of ISO 105 specifies two methods for determining the resistance of the colour of textiles of all
kinds and in all forms to the action of nitrogen oxides produced during combustion of gas, coal, oil, etc.,
and when air is passed over heated filaments.
The two tests differ in severity; one or both of them are used, depending on the result obtained (7.2.4).
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.
ISO 105-A02, Textiles — Tests for colour fastness — Part A02: Grey scale for assessing change in colour
ISO 105-F02, Textiles — Tests for colour fastness — Part F02: Specification for cotton and viscose
adjacent fabrics
ISO 139, Textiles — Standard atmospheres for conditioning and testing
ISO 3696, Water for analytical laboratory use — Specification and test methods
3 Principle
Specimens of textiles are exposed to nitrogen oxides in a closed container until either one or three
test-control fabrics exposed simultaneously with the test specimens have changed in colour to a
predetermined extent. The change in colour of each specimen is assessed with the grey scale.
4 Apparatus and materials
4.1 Exposure chamber, see Annex A.
4.2 Nitric oxide, from a commercially supplied cylinder or a generator (see Annex B).
WARNING — Nitric oxide is toxic. The maximum concentration in a working room should not
3
exceed 6,7 mg/m .
4.3 Sulfuric acid, containing 1 100 g/l of H SO (relative density 1,603).
2 4
4.4 Sodium nitrite (NaNO ), saturated solution in grade 3 water (4.13).
2
4.5 Sodium hydroxide, dilute solution (approximately 100 g/l of NaOH).
© ISO 2016 – All rights reserved 1

---------------------- Page: 11 ----------------------

SIST EN ISO 105-G01:2016
ISO 105-G01:2016(E)

4.6 Urea solution, containing 10 g/l of urea (NH CONH ), buffered to pH 7 by the addition of 0,4 g/l
2 2
of sodium dihydrogen orthophosphate dihydrate (NaH PO ·2H O) and 2,5 g/l of disodium hydrogen
2 4 2
orthophosphate dodecahydrate (Na HPO ·12H O), and containing 0,1 g/l or less of a rapid-wetting
2 4 2
surface-active agent, for example, sodium dioctyl sulfosuccinate.
4.7 Test-control fabric
4.7.1 Test-control fabric dyed with Disperse Violet 1
A woven filament
...