SIST EN 62150-5:2017

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Fibre optic active components and devices - Test and measurement procedures - Part 5: Wavelength channel tuning time of tuneable transmitters (IEC 62150-5:2017)33.180.01VSORãQRFibre optic systems in generalICS:Ta slovenski standard je istoveten z:EN 62150-5:2017SIST EN 62150-5:2017en01-oktober-2017SIST EN 62150-5:2017SLOVENSKI
STANDARD



SIST EN 62150-5:2017



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 62150-5
August 2017 ICS 33.180.20
English Version
Fibre optic active components and devices - Test and measurement procedures - Part 5: Wavelength channel tuning time of tuneable transmitters (IEC 62150-5:2017)
Composants et dispositifs actifs à fibres optiques - Procédures d'essais et de mesures -
Partie 5: Durée d'accordement des émetteurs accordables en longueur d'onde (IEC 62150-5:2017)
Aktive Lichtwellenleiter-Bauteile und -Bauelemente -
Prüf- und Messverfahren - Teil 5: Wellenlängenkanal-Abstimmzeit von abstimmbaren Sendern (IEC 62150-5:2017) This European Standard was approved by CENELEC on 2017-06-15. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique Europäisches Komitee für Elektrotechnische Normung CEN-CENELEC Management Centre: Avenue Marnix 17,
B-1000 Brussels © 2017 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 62150-5:2017 E SIST EN 62150-5:2017



EN 62150-5:2017 2 European foreword The text of document 86C/1440/FDIS, future edition 1 of IEC 62150-5, prepared by SC 86C "Fibre optic systems and active devices" of IEC/TC 86 "Fibre optics" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as EN 62150-5:2017.
The following dates are fixed: • latest date by which the document has to be implemented at national level by publication of an identical national standard or by endorsement (dop) 2018-03-15 • latest date by which the national standards conflicting with the document have to be withdrawn (dow) 2020-06-15
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice The text of the International Standard IEC 62150-5:2017 was approved by CENELEC as a European Standard without any modification. In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 60191 Series NOTE Harmonized as EN 60191 Series. IEC 60747-5 Series NOTE Harmonized as EN 60747-5 Series. IEC 60825 Series NOTE Harmonized as EN 60825 Series. IEC 62149-1 NOTE Harmonized as EN 62149-1. IEC 62150-1 NOTE Harmonized as EN 62150-1. IEC 62522 NOTE Harmonized as EN 62522. SIST EN 62150-5:2017



IEC 62150-5 Edition 1.0 2017-05 INTERNATIONAL STANDARD NORME INTERNATIONALE Fibre optic active components and devices – Test and measurement
procedures –
Part 5: Wavelength channel tuning time of tuneable transmitters
Composants et dispositifs actifs à fibres optiques – Procédures d'essais et
de mesures –
Partie 5: Durée d’accordement des émetteurs accordables en longueur d’onde
INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE
ICS 33.180.20
ISBN 978-2-8322-4277-3
® Registered trademark of the International Electrotechnical Commission
Marque déposée de la Commission Electrotechnique Internationale ®
Warning! Make sure that you obtained this publication from an authorized distributor.
Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agréé. SIST EN 62150-5:2017



– 2 – IEC 62150-5:2017 © IEC 2017 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope . 6 2 Normative references . 6 3 Terms, definitions and abbreviated terms . 6 3.1 Terms and definitions . 6 3.2 Abbreviated terms . 7 4 Apparatus . 7 4.1 Tuneable transmitter under test . 7 4.2 Optical filter set. 7 4.3 Optical-to-electrical (O/E) converter with low-pass filter (LPF). 7 4.4 Oscilloscope . 8 4.5 Control unit . 8 5 Testing and measuring procedures . 8 5.1 General . 8 5.2 Measurement procedures . 9 6 Test results . 9 6.1 Required information . 9 6.2 Information to be available on request . 10 Annex A (normative)
Optical filter set . 11 A.1 General . 11 A.2 Arrayed waveguide grating filter . 11 A.2.1 Setup . 11 A.2.2 Optical spectrum of arrayed waveguide grating filter . 11 A.2.3 Illustration of wavelength channel tuning time . 12 A.3 Etalon filter . 12 A.3.1 Setup . 12 A.3.2 Optical spectrum of etalon filter . 13 A.3.3 Illustration of wavelength channel tuning time . 13 Bibliography . 14
Figure 1 – Illustration of wavelength channel tuning time . 8 Figure 2 – Measurement setup for wavelength channel tuning time . 9 Figure A.1 – Measurement setup using arrayed waveguide grating filter . 11 Figure A.2 – Optical spectrum of arrayed waveguide grating filter . 11 Figure A.3 – Wavelength channel tuning time using arrayed waveguide grating filter . 12 Figure A.4 – Measurement setup using etalon filter . 12 Figure A.5 – Optical spectrum of etalon filter . 13 Figure A.6 – Wavelength channel tuning time using etalon filter . 13
SIST EN 62150-5:2017



IEC 62150-5:2017 © IEC 2017 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION ____________
FIBRE OPTIC ACTIVE COMPONENTS AND DEVICES –
TEST AND MEASUREMENT PROCEDURES –
Part 5: Wavelength channel tuning time of tuneable transmitters
FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 62150-5 has been prepared by subcommittee 86C: Fibre optic systems and active devices, of IEC technical committee
...