SIST EN 62262:2007/A1:2021

SLOVENSKI STANDARD
SIST EN 62262:2007/A1:2021
01-december-2021
Stopnje zaščite pred mehanskimi udarci, ki jo ohišja nudijo električni opremi (koda
IK) - Dopolnilo A1 (IEC 62262:2002/AMD1:2021)
Degrees of protection provided by enclosures for electrical equipment against external
mechanical impacts (IK code) (IEC 62262:2002/AMD1:2021)
Schutzarten durch Gehäuse für elektrische Betriebsmittel (Ausrüstung) gegen äußere
mechanische Beanspruchungen (IK-Code) (IEC 62262:2002/AMD1:2021)
Degrés de protection procurés par les enveloppes de matériels électriques contre les
impacts mécaniques externes (Code IK) (IEC 62262:2002/AMD1:2021)
Ta slovenski standard je istoveten z: EN 62262:2002/A1:2021
ICS:
29.020 Elektrotehnika na splošno Electrical engineering in
general
SIST EN 62262:2007/A1:2021 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 62262:2007/A1:2021

---------------------- Page: 2 ----------------------
SIST EN 62262:2007/A1:2021


EUROPEAN STANDARD EN 62262:2002/A1

NORME EUROPÉENNE

EUROPÄISCHE NORM
October 2021
ICS 29.020

English Version
Degrees of protection provided by enclosures for electrical
equipment against external mechanical impacts (IK code)
(IEC 62262:2002/AMD1:2021)
Degrés de protection procurés par les enveloppes de Schutzarten durch Gehäuse für elektrische Betriebsmittel
matériels électriques contre les impacts mécaniques (Ausrüstung) gegen äußere mechanische
externes (Code IK) Beanspruchungen (IK-Code)
(IEC 62262:2002/AMD1:2021) (IEC 62262:2002/AMD1:2021)
This amendment A1 modifies the European Standard EN 62262:2002; it was approved by CENELEC on 2021-10-08. CENELEC members
are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the status of a
national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.


European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN 62262:2002/A1:2021 E

---------------------- Page: 3 ----------------------
SIST EN 62262:2007/A1:2021
EN 62262:2002/A1:2021 (E)
European foreword
The text of document 70/157/FDIS, future IEC 62262/AMD1, prepared by IEC/TC 70 “Degrees of
protection provided by enclosures” was submitted to the IEC-CENELEC parallel vote and approved by
CENELEC as EN 62262:2002/A1:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022–07–08
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024–10–08
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 62262:2002/AMD1:2021 was approved by CENELEC as a
European Standard without any modification.
2

---------------------- Page: 4 ----------------------
SIST EN 62262:2007/A1:2021
EN 62262:2002/A1:2021 (E)
Annex ZA
(normative)

Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the
relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
The Annex ZA of EN 62262:2002 applies with the following changes:
Publication Year Title EN/HD Year
Delete the following reference:
IEC 60050(826) 1982 International electrotechnical vocabulary - - -
Chapter 826: Electrical installations of
buildings

Replace the following references:
IEC 60068-1 1988 Environmental testing – Part 1: General - -
and guidance
IEC 60068-2-75 1997 Environmental testing – Part 2–75: Tests -
Test Eh: Hammer tests

With the following new references:  -
IEC 60068-1 - Environmental testing - Part 1: General EN 60068-1 -
and guidance
IEC 60068-2-75 - Environmental testing - Part 2–75: Tests - EN 60068-2-75 -
Test Eh: Hammer tests


3

---------------------- Page: 5 ----------------------
SIST EN 62262:2007/A1:2021

---------------------- Page: 6 ----------------------
SIST EN 62262:2007/A1:2021



IEC 62262

®


Edition 1.0 2021-09




INTERNATIONAL



STANDARD




NORME


INTERNATIONALE





AM ENDMENT 1

AM ENDEMENT 1





Degrees of protection provided by enclosures for electrical equipment against

external mechanical impacts (IK code)




Degrés de protection procurés par les enveloppes de matériels électriques

contre les impacts mécaniques externes (Code IK)
















INTERNATIONAL

ELECTROTECHNICAL

COMMISSION


COMMISSION

ELECTROTECHNIQUE

INTERNATIONALE




ICS 29.020 ISBN 978-2-8322-1023-5




Warning! Make sure that you obtained this publication from an authorized distributor.

Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agréé.

® Registered trademark of the International Electrotechnical Commission
Marque déposée de la Commission Electrotechnique Internationale

---------------------- Page: 7 ----------------------
SIST EN 62262:2007/A1:2021
– 2 – IEC 62262:2002/AMD1:2021
© IEC 2021
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________

DEGREES OF PROTECTION PROVIDED BY ENCLOSURES
FOR ELECTRICAL EQUIPMENT AGAINST EXTERNAL
MECHANICAL IMPACTS (IK CODE)

AMENDMENT 1

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports,
Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with
may participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for
Standardization (ISO) in accordance with conditions determined by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Commi
...