SIST ISO 3007:2002

Oznaka standarda: SIST ISO 3007:2002
Koda projekta: 008082
Organizacija: SIST
Naslov (angleški): Petroleum products and crude petroleum -- Determination of vapour pressure -- Reid method
Naslov (slovenski): Naftni proizvodi in surova nafta - Določevanje parnega tlaka - Metoda po Reidu
Če kupite standardizacijski dokument v .pdf formatu prek spletne prodaje, vam nudimo 10% popust pri spodnji ceni brez DDV. Cenik SIST
Dokumenti
Ime Jezik Status Cena Dodaj v košarico
SIST ISO 3007:2002 angleški jezik Active SIST-E: 58.08 EUR
PDF
Papir
Tehnični odbor: NAD - Naftni proizvodi, maziva in sorodni proizvodi
ICS: 75.040 75.080
Status: Objavljen
Objavljen: 01-nov-2002
Refer. št. objave: Sporocila 2002-11-01
Referenčna oznaka: ISO 3007:1999
Področje projekta (angleško): This International Standard specifies a method for the determination of the vapour pressure of liquid petroleum products consisting of essentially or wholly of hydrocarbon components, or containing oxygenated hydrocarbons of specific types and at specified maximum concentrations. The method does not apply outside these concentration levels, nor to any blends containing methanol or other oxygenated hydrocarbons not covered in note 1. NOTE 1 The maximum concentration of ethers containing 5 or more carbon atoms is 15 % (V/V), and for ethanol is 10 % (V/V). For higher alcohols, the maximum concentration is 7 % (V/V). NOTE 2 For the purposes of this International Standard, the term "%(V/V)" is used to represent the volume fraction of a material. For petroleum products containing methanol, or other oxygenated hydrocarbons outside the scope of note 1, a dry vapour-pressure test method should be used. For liquefied petroleum gases, ISO 4256 should be used. The test method may be applied to volatile crude petroleum with a vapour pressure exceeding 10 kPa, although the precision has not been evaluated. Four procedures are described in this International Standard. Procedures A and B are alternative apparatus configurations for products with a Reid vapour pressure up to 180 kPa, Procedure C is applied to liquid products with a Reid vapour pressure above 180 kPa, and Procedure D applies to aviation gasolines with a Reid vapour pressure of approximately 50 kPa. Vapour pressure is an important physical property of volatile liquids, and has critical performance implications for automotive and aviation gasolines. Vapour pressure is also one of the properties affecting atmospheric evaporation, and is therefore increasingly used in regulations relating to emissions and air quality control. Vapour pressure is also a critical property limiting the performance and safety of operation of equipment during transfer operations. NOTE Because the external atmospheric pressure is counteracted by the atmospheric pressure initially in the vapour chamber, the Reid vapour pressure is approximately the "absolute" vapour pressure at 37,8 °C. The Reid vapour pressure differs from the true vapour pressure of the sample owing to slight vaporization of the sample and the pressure of water vapour and air in the confined space.
Povezava na standarde
Povezava Ime Datum
Revidiran SIST ISO 3007:1996 - Naftni proizvodi - Določanje parnega tlaka - Metoda po Reidu 12-maj-2008
Revidiran ISO 3007:1986 - Petroleum products -- Determination of vapour pressure -- Reid method 12-maj-2008


• Slovenski standardi SIST s cenovnim razredom AC so popravki standardov in so v večini primerov brezplačni.

• Slovenski standardi SIST s cenovnim razredom AP so privzeti tuji standardi, katerih sestavni del je izvirni standard, ki ga moramo pridobiti pri izdajatelju v tujini. Naročilo pošljite na: prodaja@sist.si.

Najbolje prodajani standardi