SIST EN ISO 10772:2012

SLOVENSKI STANDARD
SIST EN ISO 10772:2012
01-oktober-2012
3UHVNXVQHPHWRGH]DXJRWDYOMDQMHRGSRUQRVWLJHRWHNVWLOLMSURWLSUHFHMDQMXSUL
PRþQHPSUHWRNXYRGH,62
Test method for the determination of the filtration behaviour of geotextiles under turbulent
water flow conditions (ISO 10772:2012)
Prüfverfahren zur Bestimmung der Filterbeständigkeit von Geotextilien in turbulenten
Strömungsbedingungen (ISO 10772:2012)
Méthode d'essai relative à la détermination du comportement de la filtration des
géotextiles en conditions d'écoulement d'eau turbulentes (ISO 10772:2012)
Ta slovenski standard je istoveten z: EN ISO 10772:2012
ICS:
59.080.70 Geotekstilije Geotextiles
SIST EN ISO 10772:2012 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 10772:2012

---------------------- Page: 2 ----------------------

SIST EN ISO 10772:2012


EUROPEAN STANDARD
EN ISO 10772

NORME EUROPÉENNE

EUROPÄISCHE NORM
August 2012
ICS 59.080.70
English Version
Geotextiles - Test method for the determination of the filtration
behaviour of geotextiles under turbulent water flow conditions
(ISO 10772:2012)
Géotextiles - Méthode d'essai pour la détermination du Geotextilien - Prüfverfahren zur Bestimmung der
comportement en filtration des géotextiles en régime Filterbeständigkeit von Geotextilien in turbulenten
d'écoulement turbulent (ISO 10772:2012) Strömungsbedingungen (ISO 10772:2012)
This European Standard was approved by CEN on 14 August 2012.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 10772:2012: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 10772:2012
EN ISO 10772:2012 (E)
Contents Page
Foreword .3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 10772:2012
EN ISO 10772:2012 (E)
Foreword
This document (EN ISO 10772:2012) has been prepared by Technical Committee ISO/TC 221
"Geosynthetics" in collaboration with Technical Committee CEN/TC 189 “Geosynthetics” the secretariat of
which is held by NBN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by February 2013, and conflicting national standards shall be withdrawn
at the latest by February 2013.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 10772:2012 has been approved by CEN as a EN ISO 10772:2012 without any modification.

3

---------------------- Page: 5 ----------------------

SIST EN ISO 10772:2012

---------------------- Page: 6 ----------------------

SIST EN ISO 10772:2012
INTERNATIONAL ISO
STANDARD 10772
First edition
2012-08-15
Geotextiles — Test method for the
determination of the filtration behaviour
of geotextiles under turbulent water
flow conditions
Géotextiles — Méthode d’essai pour la détermination du comportement
en filtration des géotextiles en régime d’écoulement turbulent
Reference number
ISO 10772:2012(E)
©
ISO 2012

---------------------- Page: 7 ----------------------

SIST EN ISO 10772:2012
ISO 10772:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved

---------------------- Page: 8 ----------------------

SIST EN ISO 10772:2012
ISO 10772:2012(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principles . 1
5 Test method . 1
6 Test soils . 2
7 Sampling and sample installation . 2
8 Test apparatus . 2
9 Procedure . 3
10 Evaluation . 3
11 Test report . 4
Annex A (informative) Grading curve . 9
Bibliography .10
© ISO 2012 – All rights reserved iii

---------------------- Page: 9 ----------------------

SIST EN ISO 10772:2012
ISO 10772:2012(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 10772 was prepared by Technical Committee ISO/TC 221, Geosynthetics.
iv © ISO 2012 – All rights reserved

---------------------- Page: 10 ----------------------

SIST EN ISO 10772:2012
INTERNATIONAL STANDARD ISO 10772:2012(E)
Geotextiles — Test method for the determination of the filtration
behaviour of geotextiles under turbulent water flow conditions
1 Scope
This International Standard describes a test method for determining the soil passing through a geotextile filter
when exposed to turbulent external water flow conditions.
The test provides a value for one specific type of soil as a performance test for the design of erosion protection
layers with geotextile filters in hydraulic engineering applications.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced document
(including any amendments) applies.
ISO 9862, Geosynthetics — Sampling and preparation of test specimens
ISO 12956, Geotextiles and geotextile-related products — Determination of the characteristic opening size
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply:
3.1
soil passing value
S
pv
cumulative average soil passing value for the three specimens after the final stage
3.2
cohesion
c
u
undrained cohesion of the test soil
3.3
plasticity index
I
P
plasticity of test soil
4 Principles
The test simulates the exposure of geotextiles to turbulent conditions such as those that occur during wave
action, the passage of a ship, etc. The filtration stability of the geotextile is determined by measuring the
amount and rate of soil passing through the geotextile during the test.
5 Test method
The mechanical filtration stability of the test soil and of similar soils is determined by measuring the soil passing
through the
...