SIST EN 12234:2013
(Main)Surfaces for sports areas - Determination of ball roll behaviour
Surfaces for sports areas - Determination of ball roll behaviour
This European Standard specifies a method for determination of the rolling behaviour of a ball on a sports surface.
Sportböden - Bestimmung des Ballrollverhaltens
Die Europäische Norm legt ein Verfahren zur Bestimmung des Rollverhaltens eines Balls auf einem Sportbelag fest.
Sols sportifs - Détermination du comportement de la balle en roulement
La présente Norme européenne spécifie une méthode de détermination du comportement d'une balle en roulement sur un sol sportif.
Podloge za športne dejavnosti - Ugotavljanje obnašanja žoge pri kotaljenju
Ta evropski standard določa metodo za ugotavljanje obnašanja žoge pri kotaljenju na športni podlogi.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Podloge za športne dejavnosti - Ugotavljanje obnašanja žoge pri kotaljenjuSportböden - Bestimmung des BallrollverhaltensSols sportifs - Détermination du comportement de la balle en roulementSurfaces for sports areas - Determination of ball roll behaviour97.220.10Športni objektiSports facilitiesICS:Ta slovenski standard je istoveten z:EN 12234:2013SIST EN 12234:2013en,fr,de01-november-2013SIST EN 12234:2013SLOVENSKI
STANDARDSIST EN 12234:20031DGRPHãþD
SIST EN 12234:2013
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12234
September 2013 ICS 97.220.10 Supersedes EN 12234:2002English Version
Surfaces for sports areas - Determination of ball roll behaviour
Sols sportifs - Détermination du comportement de la balle en roulement
Sportböden - Bestimmung des Ballrollverhaltens This European Standard was approved by CEN on 11 July 2013.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2013 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 12234:2013: ESIST EN 12234:2013
EN 12234:2013 (E) 2 Contents Page Foreword . 3 1 Scope . 4 2 Normative references . 4 3 Principle. 4 4 Apparatus . 4 5 Preparation of the test specimen . 5 6 Conditioning . 6 7 Procedure . 6 8 Calculation and expression of results . 7 9 Test report . 7
SIST EN 12234:2013
EN 12234:2013 (E) 3 Foreword This document (EN 12234:2013) has been prepared by Technical Committee CEN/TC 217 “Surfaces for sports areas”, the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by March 2014, and conflicting national standards shall be withdrawn at the latest by March 2014. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 12234:2002. Compared with EN 12234:2002, the text has been clarified and editorial errors have been corrected. According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. SIST EN 12234:2013
EN 12234:2013 (E) 4 1 Scope This European Standard specifies a method for determining the rolling behaviour of a ball on a sports surface. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 12229, Surfaces for sports areas — Procedure for the preparation of synthetic turf and needle-punch test pieces EN 12235, Surfaces for sports areas — Determination of vertical ball behaviour 3 Principle A ball is rolled down a ramp, from a specified height, onto a test surface and either the distance the ball rolls or the velocity change of the ball on the surface is measured. 4 Apparatus 4.1 Ball, conforming to the regulations of the governing body of the relevant sport and as described in EN 12235. 4.2 Ball roll ramp, comprising two smooth parallel bars, mounted at an angle of (45 ± 2)° on a rigid frame, and having dimensions in accordance with Figures 1 and 2. At their lower end, the bars curve to become parallel with the ground. NOTE The spacing between the parallel bars depends on the diameter of the ball used in the test. Dimensions in millimetres
Figure 1 — Side view of ball roll ramp SIST EN 12234:2013
EN 12234:2013 (E) 5 Dimensions in millimetres
Key: (guidance width for each ball type) l
...
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Podloge za športne dejavnosti - Ugotavljanje obnašanja žoge pri kotaljenjuSportböden - Bestimmung des BallrollverhaltensSols sportifs - Détermination du comportement de la balle en roulementSurfaces for sports areas - Determination of ball roll behaviour97.220.10Športni objektiSports facilitiesICS:Ta slovenski standard je istoveten z:FprEN 12234kSIST FprEN 12234:2013en,fr,de01-marec-2013kSIST FprEN 12234:2013SLOVENSKI
STANDARD
kSIST FprEN 12234:2013
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
FINAL DRAFT
FprEN 12234
January 2013 ICS 97.220.10 Will supersede EN 12234:2002English Version
Surfaces for sports areas - Determination of ball roll behaviour
Sols sportifs - Détermination du comportement de la balle en roulement
Sportböden - Bestimmung des Ballrollverhaltens This draft European Standard is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee CEN/TC 217.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2013 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. FprEN 12234:2013: EkSIST FprEN 12234:2013
FprEN 12234:2013 (E) 2 Contents Page Foreword . 3 1 Scope . 4 2 Normative references . 4 3 Principle. 4 4 Apparatus . 4 5 Preparation of the test specimen . 5 6 Conditioning . 6 7 Procedure . 6 8 Calculation and expression of results . 7 9 Test report . 7
kSIST FprEN 12234:2013
FprEN 12234:2013 (E) 3 Foreword This document (FprEN 12234:2013) has been prepared by Technical Committee CEN/TC 217 "Surfaces for sports areas", the secretariat of which is held by AFNOR. This document is currently submitted to the Formal Vote. This document will supersede EN 12234:2002. kSIST FprEN 12234:2013
FprEN 12234:2013 (E) 4
1 Scope This European Standard specifies a method for determination of the rolling behaviour of a ball on a sports surface. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 12229, Surfaces for sports areas — Procedure for the preparation of synthetic turf and textile test pieces. FprEN 12235, Surfaces for sports areas — Determination of vertical ball behaviour
3 Principle A ball is rolled down a ramp, from a specified height, onto a test surface and either the distance the ball rolls or the velocity change of the ball on the surface is measured. 4 Apparatus 4.1 Ball, conforming to the regulations of the governing body of the relevant sport and as described in EN 12235. 4.2 Ball roll ramp, comprising two smooth parallel bars, mounted at an angle of (45 ± 2) º on a rigid frame, and having dimensions in accordance with Figures 1 and 2.
At their lower end, the bars curve to become parallel with the ground.
NOTE The spacing between the parallel bars depends on the diameter of the ball used in the test.
Dimensions in millimetres
Figure 1 — Side view of ball roll ramp kSIST FprEN 12234:2013
FprEN 12234:2013 (E) 5 Dimensions in millimetres
Key: (guidance width for each ball type) l = 100 ± 10 mm association Football l = 45 ± 5 mm hockey Figure 2 — Plan of ball roll ramps 4.3 Bubble level, suitable for measuring vertical and horizontal alignment. 4.4 Alignment device, suitable for setting the ball roll ramp vertically on a level surface. 4.5 Tape measure, for determination of all rolling distances. 4.6 Set of opticall
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.