SIST EN 820-5:2009

Oznaka standarda: SIST EN 820-5:2009
Koda projekta: 00184214
Organizacija: SIST
Naslov (angleški): Advanced technical ceramics - Thermomechanical properties of monolithic ceramics - Part 5: Determination of elastic moduli at elevated temperatures
Naslov (slovenski): Sodobna tehnična keramika - Termomehanske lastnosti monolitske keramike - 5. del: Ugotavljanje elastičnih modulov pri povišanih temperaturah
Če kupite standardizacijski dokument v .pdf formatu prek spletne prodaje, vam nudimo 10% popust pri spodnji ceni brez DDV. Cenik SIST
Dokumenti
Ime Jezik Status Cena Dodaj v košarico
SIST EN 820-5:2009 angleški jezik Active SIST-F: 65.34 EUR
PDF
Papir
Tehnični odbor: I13 - Imaginarni 13
ICS: 81.060.30
Status: Objavljen
Objavljen: 01-sep-2009
Refer. št. objave: Sporočila 2009-09
Referenčna oznaka: EN 820-5:2009
Področje projekta (angleško): This part of EN 820 describes methods for determining the elastic moduli, specifically Young's modulus, shear modulus and Poisson's ratio, of advanced monolithic technical ceramics at temperatures above room temperature. The standard prescribes three alternative methods for determining some or all of these three parameters: A the determination of Young's modulus by static flexure of a thin beam in three- or four-point bending. B the determination of Young's modulus by forced longitudinal resonance, or Young's modulus, shear modulus and Poisson's ratio by forced flexural and torsional resonance, of a thin beam. C the determination of Young's modulus from the fundamental natural frequency of a struck bar (impulse excitation method). This part of EN 820 extends the above-defined room-temperature methods described in EN 843-2 to elevated temperatures. All the test methods assume the use of homogeneous test pieces of linear elastic materials. The test assumes that the test piece has isotropic elastic properties. At high porosity levels all of the methods can become inappropriate. The maximum grain size (see EN 623-3), excluding deliberately added whiskers, should be less than 10 % of the minimum dimension of the test piece. NOTE 1 Method C in EN 843-2 based on ultrasonic time of flight measurement has not been incorporated into this part of EN 820. Although the method is feasible to apply, it is specialised, and outside the capabilities of most laboratories. There are also severe restrictions on test piece geometries and methods of achieving pulse transmission. For these reasons this method has not been included in EN 820-5. NOTE 2 The upper temperature limit for this test depends on the properties of the test pieces, and can be limited by softening within the timescale of the test. In addition, for method A there can be limits defined by the choice of test jig construction materials.
Povezava na standarde
Povezava Ime Datum
Nadomešča SIST-TS CEN/TS 820-5:2005 - Sodobna tehnična keramika – Metode za preskušanje monolitske keramike – Termomehanske lastnosti – 5. del: Ugotavljanje elastičnih modulov pri povišanih temperaturah 01-sep-2009


• Slovenski standardi SIST s cenovnim razredom AC so popravki standardov in so v večini primerov brezplačni.

• Slovenski standardi SIST s cenovnim razredom AP so privzeti tuji standardi, katerih sestavni del je izvirni standard, ki ga moramo pridobiti pri izdajatelju v tujini. Naročilo pošljite na: prodaja@sist.si.

Najbolje prodajani standardi