SIST-TS CLC/TS 50430:2006

Oznaka standarda: SIST-TS CLC/TS 50430:2006
Koda projekta: 16182
Organizacija: SIST
Naslov (angleški): Optical fibre cables - Gas pipe cables - Family specification for cables to be installed in high pressure gas pipes
Naslov (slovenski): Optični kabli – Kabli za polaganje v plinske cevi – Rodovna specifikacija za kable, namenjene za napeljavo po visokotlačnih plinskih ceveh
Če kupite standardizacijski dokument v .pdf formatu prek spletne prodaje, vam nudimo 10% popust pri spodnji ceni brez DDV. Cenik SIST
Dokumenti
Ime Jezik Status Cena Dodaj v košarico
SIST-TS CLC/TS 50430:2006 angleški jezik Active SIST-G: 72.60 EUR
PDF
Papir
Tehnični odbor: iTEL - Telekomunikacijski vodi
ICS: 33.180.10
Status: Objavljen
Objavljen: 01-mar-2006
Refer. št. objave: Sporocila 2006-03-01
Referenčna oznaka: CLC/TS 50430:2005
Področje projekta (angleško): This document is a family specification that covers gas pipe cables and sub-ducts for installation by blowing and/or pulling / dragging in high pressure gas pipes. Systems built with components covered by this standard are subject to the requirements of sectional specifications EN 60794-3 and EN 60794-4 where applicable. Gas pipe cable and sub-duct constructions have to meet the different requirements of the gas- companies and/or associations regarding chemical, environmental, operational interactions and in general maintenance conditions. A table of preferential applications, describing gas pipe cable characteristics versus methods of installation is reported in Annex A for high pressure gas pipe cables. Clause 4 describes a blank detail specification for gas pipe cables and sub-ducts for installation by blowing and/or pulling / dragging in/into high pressure gas pipes. It incorporates some minimum requirements. Detail specifications may be prepared on the basis of this family specification. The parameters specified in this standard may be affected by measurement uncertainty arising either from measurement errors or calibration errors due to lack of suitable standards. Acceptance criteria should be interpreted with respect to this consideration. The number of fibres tested is representative of the sewer cable and should be agreed between the customer and supplier.

Najbolje prodajani standardi